Question
Show drawing name instead of model name
I have done this many time but I am drawing a blank this morning. Our drawing formats show the model name (assembly or part) in the title block
There are a few occasions where you instead want to show the actual name of the drawing file.
What parameter do I need to use? Does it need to be in a table or repeat region?
I had thought it was &model_name:d but that doesn't seem to work...
Wildfire 4.0 M220 (...I know, I know...)
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
There are a few occasions where you instead want to show the actual name of the drawing file.
What parameter do I need to use? Does it need to be in a table or repeat region?
I had thought it was &model_name:d but that doesn't seem to work...
Wildfire 4.0 M220 (...I know, I know...)
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.