Problems with else if commands

[ptc-6651667]

Hi All,

I am very new to Matchcad Prime 3. I am trying to do a programing which is given as screen shots below. I don't know it is the effective way of doing it. Please correct me if any of my calculations were wrong.

I am trying interpret the follwing table to Mathcad programming.

I have attached my Mathcad file which explains my calculations. Please help

[MikeArmstrong]

If you want my honest opinion I would suggest against trying to automate this. I regularly use this standard and find manually selecting the correct case the easiest way.

[ptc-6651667]

Hi Mike,

Thanks for your suggestion.

However I'm halfway through it. I would like to finish it off, as I have spent quite a lot of time in there.

[MikeArmstrong]

Thiyaga Thiliban Chandru wrote:

Hi Mike,

Thanks for your suggestion.

However I'm halfway through it. I would like to finish it off, as I have spent quite a lot of time in there.

I'm sure someone will offer some guidance, but at the minute I cannot really afford any time.