topic Re: Model CHECK Clear relation in 3D Part & Assembly Design

Model CHECK Clear relation

AHardy — Wed, 23 Jun 2021 07:34:52 GMT

Hi,

I know PRT_REL_UNWANTED, it can be used to remove one relation,

but if we don't know the relations, how is possible to remove all?

thank's

Re: Model CHECK Clear relation

KenFarley — Wed, 23 Jun 2021 10:55:59 GMT

From what I can see there is no such capability, probably because it is dangerous. Removing all the relations in a model without knowing what they do could screw up any number of things. For example, I often use relations to define the description of a part that will be put into a bill of materials. A shaft might have relations that define a retaining ring slot's dimensions based upon the part's diameter. There are lots of cases where the relations are what makes the model correct, particularly if a top-level assembly is being used to drive the component dimensions.

Re: Model CHECK Clear relation

AHardy — Wed, 23 Jun 2021 11:46:42 GMT

thank's, yes i know it's dangerous

Re: Model CHECK Clear relation

manjunathrv — Thu, 24 Jun 2021 03:11:44 GMT

You have to know the exact relation to clear from ModelCHECK.

Re: Model CHECK Clear relation

AHardy — Fri, 25 Jun 2021 09:45:19 GMT

yes i think the solution it's to know all relations