topic Re: How to configure a pentable file for pdf export in 3D Part & Assembly Design

How to configure a pentable file for pdf export

VladimirPalffy — Fri, 07 Dec 2018 17:52:17 GMT

In this video tutorial you can learn - how to correctly export Creo drawing to pdf file

Tags: #creo #creoparametric #creotutorial #tutorial #4kside #palffy #vpalffy #vladimirpalffy

Re: How to configure a pentable file for pdf export

PM7 — Thu, 05 Sep 2019 15:06:09 GMT

l have an issue in regards to exporting the PDF as the drawing line are thicker. How can l solve this as shown by drawing below ?

Re: How to configure a pentable file for pdf export

StephenW — Thu, 05 Sep 2019 15:51:04 GMT

The video shows you how to set up a pen table file. If the line weights aren't correct, adjust the values in the pen table file until they work for you.

Re: How to configure a pentable file for pdf export

mbonka — Mon, 09 Sep 2019 16:24:53 GMT

See time 2:10.

Set desired value instead of 0,013 in your pentable.txt file. Try to test all rows with some little bit different values. Maybe you will need restart Creo before changes will be active.

Best regards

@mbonka

Re: How to configure a pentable file for pdf export

dgrobe — Wed, 25 Aug 2021 21:32:16 GMT

i have an issue where my pdf for my D size looks great, but B size is thicker lines.

Re: How to configure a pentable file for pdf export

VladimirPalffy — Thu, 02 Sep 2021 08:37:19 GMT

Hi, try to check if the system loads the correct pentable file for both exports