topic prt file cannot be unbend in 3D Part & Assembly Design

prt file cannot be unbend

ahmet.gunes — Mon, 18 Mar 2024 07:11:33 GMT

Hello, the unbend command in the attached file fails. Can you help?

Re: prt file cannot be unbend

MartinHanak — Mon, 18 Mar 2024 08:17:21 GMT

Hi,

you cannot unbend solid geometry. Unbend command can only be applied to sheetmetal geometry. Also Unbend command can only be applied to ruled surfaces (zero Gaussian curvature).

Re: prt file cannot be unbend

ahmet.gunes — Mon, 18 Mar 2024 08:24:32 GMT

Hi MartinHanak

Yes sheet metal I turned it but it didn't work

Re: prt file cannot be unbend

MartinHanak — Mon, 18 Mar 2024 08:28:23 GMT

@ahmet.gunes wrote:

Hi MartinHanak

Yes sheet metal I turned it but it didn't work

Hi,

please send your part again. I suggest you to build the part in Sheetmetal mode. Do not convert solid geometry into sheetmetal geometry. Also do not forget that Unbend command can only be applied to ruled surfaces (surfaces with zero Gaussian curvature). Please check Gaussian curvature of your model.

Re: prt file cannot be unbend

ahmet.gunes — Thu, 21 Mar 2024 06:24:50 GMT

My manager asked me to have the piece expanded in this way, is it possible?