topic UNABLE TO SELECT MULTIPLE SUB ASSEMBLIES CREO 4 in 3D Part & Assembly Design

topic UNABLE TO SELECT MULTIPLE SUB ASSEMBLIES CREO 4 in 3D Part & Assembly Design https://community.ptc.com/t5/3D-Part-Assembly-Design/UNABLE-TO-SELECT-MULTIPLE-SUB-ASSEMBLIES-CREO-4/m-p/352803#M3236 <HTML><HEAD></HEAD><BODY><P>it is nearly impossible to select multiple sub-assemblies with the new geometry based filter.  I have spoke with PTC and with a very convoluted non-intuitive method finally was able to perform this task.  To prevent me from jumping off my desk, I created a couple of mapkeys to add parts and components to "my filter" and another to reset it back to geometry once my selection was complete.  Has anyone else encountered this and what did you do to resolve this?</P></BODY></HTML> Thu, 03 May 2018 03:03:46 GMT mbrockman 2018-05-03T03:03:46Z UNABLE TO SELECT MULTIPLE SUB ASSEMBLIES CREO 4 https://community.ptc.com/t5/3D-Part-Assembly-Design/UNABLE-TO-SELECT-MULTIPLE-SUB-ASSEMBLIES-CREO-4/m-p/352803#M3236 it is nearly impossible to select multiple sub-assemblies with the new geometry based filter.  I have spoke with PTC and with a very convoluted non-intuitive method finally was able to perform this task.  To prevent me from jumping off my desk, I created a couple of mapkeys to add Thu, 03 May 2018 03:03:46 GMT https://community.ptc.com/t5/3D-Part-Assembly-Design/UNABLE-TO-SELECT-MULTIPLE-SUB-ASSEMBLIES-CREO-4/m-p/352803#M3236 mbrockman 2018-05-03T03:03:46Z