topic RE: GD&T w/ dual dim's -how to change decimal places? in 3D Part & Assembly Design

GD&T w/ dual dim's -how to change decimal places?

sshannon — Sun, 13 Dec 2020 03:42:40 GMT

I have a print that is dual dimensioned. (mm primary -inch secondary w/ the display set to secondary[primary])

The problem I'm having is in the geomentric tolerances. The value is shown as .0 [0.02].

Anybody know how to change the decimal places of the secondary to show as .001 [0.02]?

Regards,

Steve Shannon

Tooling Engineer

matic

300 East 48th St.

Holland, MI 49423

phone (616) 820-2427

fax(616) 820-2488

www.transmatic.com

mailto:-

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

RE: GD&T w/ dual dim's -how to change decimal places?

DeanLong — Wed, 07 Dec 2011 22:00:30 GMT

Should be a combo solution in your drawing setup file.

Dual_digits_diff

lead_trail_zeros

Your feature control frame values will follow the dim decimal places and zeros configuration.

RE: GD&T w/ dual dim's -how to change decimal places?

DeanLong — Wed, 07 Dec 2011 22:01:53 GMT

Oh....make sure your lead_trail_zeros_scope is set to "all". It should be as it is the default value. Check it regardless.

In Reply to Dean Long:

Should be a combo solution in your drawing setup file.

Dual_digits_diff

lead_trail_zeros

Your feature control frame values will follow the dim decimal places and zeros configuration.