topic Re: Sweeping issue in 3D Part & Assembly Design

Sweeping issue

rholt — Thu, 03 May 2018 02:59:30 GMT

Hi AllI'm relatively new to using Creo and have been going through a number of tutorials given to me, and have gotten stuck at something that seems fairly rudimentary and I hope I'm just missing something simple. Whilst trying to sweep to generate the second image attached

Re: Sweeping issue

MartinHanak — Fri, 19 May 2017 08:37:13 GMT

Hi,

I was able to create following sweep.

If you can upload your model. I'll check it.

See How to Attach a File to a Discussion Reply

Re: Sweeping issue

Mahesh_Sharma — Fri, 19 May 2017 12:44:06 GMT

Russell,

Try editing sweep and Select the Allows section to be changed based on parametric references or relations along the sweep icon from the feature dashboard.

If this still fails, upload the model (as Martin mentioned in last reply)

Re: Sweeping issue

rholt — Mon, 22 May 2017 03:24:34 GMT

I've attached both the tutorial model, and an attempt done by myself to get the model to sweep

I attempted to use the allows section to be changed based on parametric references or relations along the sweep icon however I found myself unable to make it generate.

Martin Hanak‌

Thank you both in advance

Re: Sweeping issue

MartinHanak — Mon, 22 May 2017 12:13:44 GMT

Hi,

Original model contains Sketch 1 with two arcs with radius 25.

Sketch 1 in your model contains wrong radius value 1 related to one of arcs. Modify it to 25 and you will get proper sweep geometry.