Ｄｒａｗｉｎｇｓ ａｂｏｕｔ ｔｏｌｅｒａｎｃｅ ｔａｂｌｅ

[Jacky.Dong]

ｈｅｌｌｏ　ｅｖｅｒｙｏｎｅ

ｗｈｙ　Ｉ　ｃａｎ＇ｔ　ｆｉｎｄ　ｔｈｅ　ｓｈａｆｔ　ａｎｄ　ｈｏｌｅ　ｉｎ　ｔｈｅ　ｆｉｒｓｔ　ｄｒａｗｉｎｇ．ｗｈａｔ　ｓｈｏｕｌｄ　Ｉ　ｄｏ　ｔｏ　ｍａｋｅ　ｔｈｅ　ｓｈａｆｔ　ｏｒ　ｈｏｌｅ　ｏｐｔｉｏｎ　ａｐｐｅｒａｎｃｅ，ｌｉｋｅ　ｔｈｅ　ｓｅｃｏｎｄ　ｐｉｃｔｕｒｅ

ｔｈａｎｋｓ　ｉｎ　ａｄｖａｎｃｅ．

[tbraxton]

Most likely you need to load the hole/shaft tolerance in your models. Follow the thread below and see if the steps outlined resolve the issue.

ISO Standard Fits and Tolerances - PTC Community

[Jacky.Dong · Accepted solution]

ok, thanks a lot. and here is my actual action. also for others who suffer from this question to refer.

right now I know there is two way to retrieve the tolerance table. one is in the drawing mode, the other is in the 3D mode

At first, I only retrieved the tolerance table in the 3D mode. that is why I can't find the "shaft" or"hole" when I want to mark a dimension on the draft, but it works with the dimension on the Molel.

when I retrieved the torlance table in drawing mode, it works.

thanks again😊