Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily.
X
Does anyone know how to get the note that is generated using the hole feature to show up on a drawing of a mirrored part? The hole was created in the base part, but I need it to show up on the mirrored part drawing.
Christopher Rees - Mechanical Engineer - ISR Systems UTC AEROSPACE SYSTEMS 100 Wooster Heights Rd, Danbury, CT 06810 U.S.A. Tel: +1 203 797 5490 Fax: +1 203 797 6637 christopher.rees@utas.utc.com<">mailto:christopher.rees@utas.utc.com>www.utcaerospacesystems.com This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.