cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Adding features to a family table

nicfre1
1-Newbie

Adding features to a family table

Pro-Super-Incredible-Gurus,
I am trying to complete a simple task in Pro-E. I have a length of angle and
I am extruding holes through the angle. I have several different hole
configurations that run down the length of the angle. So far I have created
2 configurations, added them to the family table and selected "yes" or "no"
for the appropriate instances. I have just created a third configuration,
but I cannot add it to the family table. It is not referenced to any other
feature. It is a simple extruded cut like the other two features. I am at a
loss to explain this one. I have done simple cuts and added them to the
family table countless times before. Does anyone know what I am doing wrong?

Nick

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1

Gurus,
I should have tried this before I send this question. I closed out of the
part, erased from memory and then went back in and tried to add feature 3 to
the family table. Guess what? It worked. Go figure.

Nick
Announcements