I'm new to this exploder list so if my question is not relevant maybe
you can point me in the right direction.
I have a Pro-e drawing that has some jpg objects inserted into it.
When I plot my drawing to a printer I can see all the jpg objects fine.
If I make a PDF from my drawing the jpg objects don't show up.
Is there some setting that I can change within Pro-e that would allow
Adobe PDF to capture the jpg images? Or a setting in Adobe that would
allow this?
Robert Parsons
Contract Designer
7300 Friendly Ave.
Greensboro, NC. 27409
Phone 336-547-5604
This message (including any attachments) contains confidential
and/or proprietary information intended only for the addressee.
Any unauthorized disclosure, copying, distribution or reliance on
the contents of this information is strictly prohibited and may
constitute a violation of law. If you are not the intended
recipient, please notify the sender immediately by responding to
this e-mail, and delete the message from your system. If you
have any questions about this e-mail please notify the sender
immediately.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
