cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Apply custom default bom balloon type in dtl

Durbal.Andrew.H
8-Gravel

Apply custom default bom balloon type in dtl

 

 

Make it possible to change the default dtl line command of default_bom_balloon_type line from simple_circle to 'bom_balloon_1' for example to enable the assembly balloons to be shown correctly on new drawings.

 

 

 

Current workaround is to include the symbol somewhere on the drawing template and then this option will work as opposed to pointing to a symbol library.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1

Hello Andrew,

A very good tip ! Thanks a lot.

The only little problem remaining is that a symbol with just the model_name (no geometry) is not automatically adjust with the syze of the name.
It's not too bad for us because all parts should have the same size name.
I think PTC should support a bom balloon type "model_name" with an automatic size changing with the part name size.--> idea 4287
Thanks again. Fabrice.

Announcements