Question of my day today.
I got this drawing that I'm trying to release. Every time I open it, I see
that the assembly got plused+ (modfied if you will) The assembly seems to
not get plused+ on its own, only when I open the drawing.
Any ideas what to look for on the drawing that might be modifying the
assembly when the drawing is opened? We are using intralink 3.3 but I've
seen this on PDMlink too and I was not able to figure out why. The
importance of the assembly not modifying on its own is that I know it has no
circular refs to cause it to auto modify some how. The drawing, I think
must be doing something to auto regenerate the assembly only (drawing stays
nice and unplused+)
regards,
Alfonso
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
