cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

BSPT Pipe Thread Programming in Creo Parametric

ScottJohnson
14-Alexandrite

BSPT Pipe Thread Programming in Creo Parametric

Anyone try to define a BSP or BSPT thread in Creo? Do we try custom tools or maybe define it as a tapered mill? Even without any check surfaces the tap I defined will not go past the start surface.

1 REPLY 1

There probably is no specific drilling or milling sequence for tapered threads.

If you use a drilling sequence, you may use a customized cycle to define what is needed for the machine

When using a milling sequence, you could probably use trajectory milling, but you will have to design the curve (as drive surface cut again only allows verticval surfaces, i.e. no taper angle)

Top Tags