cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you know you can set a signature that will be added to all your posts? Set it here! X

Blend Section to Surfaces

VladimirPalffy
13-Aquamarine

Blend Section to Surfaces

Short demonstration of how to create a feature Blend Section to Surfaces

 


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Best Regards,
Vladimir Palffy
6 REPLIES 6

It's amazing how some features that are not used often by many could easily be forgotten.   Thank you for sharing this great feature that may be overlooked by many.

Thanks

Best Regards,
Vladimir Palffy

thats great but what if you had to hold 5 degrees on that wall.  you dont always know where the curve would be on the bottom surface.  can you do that with this tool or is there another that you could hold tangent to the top piece and hold angle of 5 degrees down to the bottom surface.

thanks.

You don't forget - you can always create a draft analysis (check draft)

Best Regards,
Vladimir Palffy

nice tutorial

Thanks Steve

Best Regards,
Vladimir Palffy
Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags