Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hi,
Can we use a specific parameter to control whether another parameter is designated or not? Linked to topic - https://community.ptc.com/t5/3D-Part-Assembly-Design/Unchecking-Designate-parameters/m-p/754245#M121251
Appreciate your help.
I think this is duplicate of mentioned discussion.
This post is developing the topic referenced from 2021. Let's see if the Community can chime in.
in my first reply I did not mention the right discussion. The right link is https://community.ptc.com/t5/3D-Part-Assembly-Design/How-to-control-designated-parameters-in-Creo-Parametric/m-p/863451
