Center line become solid line after convert .PDF from .drw file

[SS_9710102]

Hi Gents,

I am using Creo 4.0

• In .drw file hole center line looks like perfect. shown in below Fig 1

FIG:-1

• After converting .pdf file from .drw its looks like solid line shown in below Fig.2.
• Is there any way to show center line as same as .drw or similar. 

FIG:-2

[StephenW]

I think your answer is in this post https://community.ptc.com/t5/3D-Part-Assembly-Design/Save-as-PDF-hidden-lines-are-very-short-dashed-lines-not-scaled/m-p/680338