Chamfer/Round

[DieselPig]

Morning All

I am trying to create a round or chamfer in the area marked with no success, the rib is just touching a sphere. Any ideas?

The model is attached.

[manjunathrv]

try to reorder the rounds. The smaller rounds on the ribs can be added after the chamfer or the round that you are trying to create.

[DieselPig]

Hi Manjunath

I still cannot create a chamfer or round at this point. I deleted all the chamfers and rounds and tried a different order but no luck.

Any pointers?

[manjunathrv]

See attached part. I had to edit the Extrude_5 and re-add the rounds around...

[DieselPig]

Thanks MRV

What was wrong with Extrude_5 to cause that problem? I could see a step but it was very small.

Regards

Phil

[manjunathrv]

That curve in the sketch was a spline and the end was not aligned properly to the ends of the revolve. I replaced that spline by projecting the edge of the Revolve.

[DieselPig]

Another edge that refuses a round!

I cannot get this inside edge to take a round.

[manjunathrv]

That was easy one....

[DieselPig]

Hi MRV

Yes I forgot to use variable round and it works!

Regards

Phil