Cosmetic Thread of drafted surface

[himungan]

When i apply standard type of cosmetic thread on drafted surface, depth value is grey out as seen in screenshot available in attachment

[kdirth]

You need to select the surface to start the thread from first (end of the cylinder).

Also, it has defaulted to a tapered pipe thread which has a standard length.

[himungan]

No difference. It is just the reference for depth value

[kdirth]

If you are trying to create a standard straight thread on a drafted cylinder, you need to create the cosmetic thread then draft the cylinder.  Otherwise Creo defaults to a tapered pipe thread.

[himungan]

However some standard not seen without drafted surface such as NPTF and NPF standards.