cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Create Sheetmetal using a line

MaikTheBike
Moonstone

Create Sheetmetal using a line

Hi,

 

I try to rebuild a Project that has been created in Fusion 360.

In this Project a sheet of metal is created from a line in a Sketch and I want to do the same thing in Creo.

The thickness is 8mm. 

How can I do this in Creo (with bending-radius and correct dimensioning)? Do I have to use the Sheetmetal-environment ?

 

Thanks,

Maik

linie1.JPGlinie2.JPG

3 REPLIES 3

Re: Create Sheetmetal using a line

Extrude the line using thicken sketch, then convert it to sheetmetal and add bends to the corners using conversion.

 

Capture.JPG


There is always more to learn in Creo.

Re: Create Sheetmetal using a line

You can also start in sheetmetal and skip the conversion by using Extrude.  The line sketch is thickened and bends are added, both values can be set in the tool.


There is always more to learn in Creo.

Re: Create Sheetmetal using a line

Very nice. Thanks. It works perfectly.

Announcements