Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hi
In previous versions of Creo pairs Clearance between 2 parts, highlighted only the interfering volume.
In Creo 1.0 the whole parts are highlighted, and the interference is hard to see.
It also affect the performance.
Is it possible to turn off the highlighting of the selected parts?
I'm encountering this issue now that I've starting using creo 1/2. This is a huge problem. It's impossible to see the intereference.