cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can subscribe to a forum, label or individual post and receive email notifications when someone posts a new topic or reply. Learn more! X

Creo 10 -- printing centerlines -- proper scale

steved
3-Newcomer

Creo 10 -- printing centerlines -- proper scale

I'm trying to get centerlines to print properly, either on paper or PDF.  My DRW is shown in 1st pic.  The centerlines are adjusted so that each hole has the small dashes in the center.  The 2nd pic is what the PDF output looks like -- small dashes are gone.  I found plot_linestyle_scale setting, which does exactly what I'm looking for, but for the DOTFONT line style (hidden lines).  Anybody know how to similarly adjust scaling factor for CTRLFONT line style?

5 REPLIES 5
MartinHanak
24-Ruby III
(To:steved)

Hi,

it would be helpful to upload testing data.


Martin Hanák

Thank you for the response Martin.  I am trying to attach the relevant files (PRT, DRW, PDF), but I'm getting this error message:

 

Correct the highlighted errors and try again.

  • The attachment's ft-37653.prt content type (application/octet-stream) does not match its file extension and has been removed.

 

Steve Drake

MartinHanak
24-Ruby III
(To:steved)


@steved wrote:

Thank you for the response Martin.  I am trying to attach the relevant files (PRT, DRW, PDF), but I'm getting this error message:

 

Correct the highlighted errors and try again.

  • The attachment's ft-37653.prt content type (application/octet-stream) does not match its file extension and has been removed.

 

Steve Drake


Hi,

please pack all files into single zip file and upload this file.


Martin Hanák

Thanks again Martin.  Here is ZIP file.

MartinHanak
24-Ruby III
(To:steved)


@steved wrote:

Thanks again Martin.  Here is ZIP file.


Hi,

I opened your drawing in Creo 10.0.6.0 and generated PDF using Save As command. See attachment.

 

My config.pro contains following options:

use_8_plotter_pens yes
pen_table_file E:\users\creo7_parametric\pentable.pnt
pdf_use_pentable YES

 

E:\users\creo7_parametric\pentable.pnt

pen  1   thickness 0.05 cm;  color 0.0 0.0 0.0
pen  2   thickness 0.025 cm; color 0.0 0.0 0.0
pen  3   pattern 0.5, 0.2 cm; thickness 0.025 cm; color 0.0 0.0 0.0
pen  4   thickness 0.035 cm; color 0.0 0.0 0.0
!*** pen  5 ... sheetmetal
pen  5   thickness 0.07 cm; color 0.0 0.0 0.0
pen  7   thickness 0.015 cm; color 0.0 0.0 0.0
pen  8   thickness 0.035 cm; color 0.0 0.0 0.0
pen  9   thickness 0.035 cm; dimmed_color

 

Suggestion:

  • rename your config.pro files to put them out of service
  • start Creo, open drawing, generate PDF
  • if axis in PDF are generated as requested then some config.pro option is the root of the problem

 


Martin Hanák
Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags