Community Tip - You can subscribe to a forum, label or individual post and receive email notifications when someone posts a new topic or reply. Learn more!
X
A trick I learned a long time ago for cutting a part at a plane was to pick a plane, then use Edit --> Solidify. You pick which side of the plane it removes. When it was applicable, it was much faster and more robust than creating an extruded cut to remove the material.
Worked through WF5.
Now using Creo 2. I've selected a datum plane, but the Solidify option is greyed out. What gives?
-- Andrew
Andrew Kelly, P.E. Design Engineer Honeywell Sensing and Control 2080 Arlingate Lane Columbus, OH 43228 Office: 614-850-7818 Toll Free: 800-848-6564 Fax: 614-850-1111 andrew.kelly@honeywell.com<">mailto:andrew.kelly@honeywell.com>
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
