Creo 3.0 config setting to default extrude.

[creed-4]

Is there a config setting to default the extrude to remove material instead of adding on?  When making cuts and extrudes in a design it would require less mouse clicks to remove material by default.

Thank you in advance.

C.Reed

[AmitDeshpande]

Hi Cheryl,

Sorry, but that's not possible.  There isn't a way to set the default to be Remove Material.  You can create a mapkey that starts the extrude dashboard and clicks the Remove Material icon.

Thanks,

Amit

[creed-4]

Hi Amit,

It would be nice to be able to change this in the configurations.  I will try the mapkey.

Thanks so much.

Cheryl