Creo 7.0.8.0 Cable Manufacturing - Cable flatten break feature

[ASA]

I can't seem to delete a cable break after placing it. I don't see the "X" that is supposed to represent the cable break in the flat model. Anyone experienced this issue?

The only way I have been able to successfully delete it is to delete the entire cable segment.

[anursingh]

Hi @ASA,

Thank you for your question. 

Your post appears well documented but has not yet received any response. I am replying to raise awareness. Hopefully, another community member will be able to help.

Also, feel free to add any additional information you think might be relevant. It sometimes helps to have screenshots to better understand what you are trying to do. 

Regards,

Anurag