Creo Composites trim option

[NareshJ]

Hi,

I am new to this Creo composites module, i would like to seek your help on few queries related to composites.

1. While we add multiple Ply on a model, how can we change the sequence when we are trimming the ply based on my requirements. Currently the ply sequence is opposite from my expectations. Attached image for your reference.

2. How do we understand what is wrong when we see the Drape status as can't able to drape in drape manager window? What should be corrected? how to analyze?

3. Can we manage the length of the ply manually? likewise while we apply the first ply we should be able to manage the length or key in the length value? is this possible?

Thanks

Naresh

[Catalina]

Hi @NareshJ 

Thank you for your question. 

Your post appears well documented but has not yet received any response. I am replying to raise awareness. Hopefully, another community member will be able to help.

Also, feel free to add any additional information you think might be relevant.

Best regards,