cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Stay updated on what is happening on the PTC Community by subscribing to PTC Community Announcements. X

Cyclic Symmetry, Pressure Loads on assembly

gmarjason
1-Visitor

Cyclic Symmetry, Pressure Loads on assembly

Hi,

I am running Creo 3 Simulate, we are trying to determine the stress within the walls of a pressure vessel assembly from external pressure, but using cyclic symmetry to speed up the process.

The model runs ok and the analysis completes, but the result is always far beyond the material yield turning the model red, this happens even if the external pressure load is very low, say around 100psi, the material yield is 130ksi, the walls are more than capable of with standing this pressure, normal operating pressure would be 10kpsi.


Thanks


Geoff.



This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
3 REPLIES 3
unickque
12-Amethyst
(To:gmarjason)

Geoff, can you share your model so we can have a look at it?

Seems like a unit error... I see also that you have sharp reentrant corners, you may end up with non-converging high stresses in those locations. This is where the linearized stress query can be used with some norm, for dimensioning.

Might also be incorrect constraints; it looks as if there are deformations perpendicular to the symmetry planes near the sharp corners. And that long thin red artefact in the right top seems odd as well.

Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags