Dimension Break Line does not work upon Regen ....

[ptc-4606185]

Annotation ( CoCreate vs. 17 😞 Does anybody know why the "Modify Dimension Break Line" command reverts back to the original "non-modified" state as a result to View Updating? This is very annoying, because of all the extra work it creates. What's more, no drawing should be put into an unreliable state after having confidence that a particular version is approved!

Thanks.

-- Stephan

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[hkramer]

Hello,

if you have a valid and active Maintenace contract can you please take/report this to the Technical Support group of PTC ? then they would be able to verify this and to report this to R&D if it requires a change in the implementation.

Horst