Dimension line size in inspection mode

[MohaSharifi]

When I add an inspection circle to some dimensions, the dimension line extends more than required. In the following figure, this condition is shown, could anyone help me adjust it (PTC Creo 2)?

[vnamboodheri]

Hello @MohaSharifi, 

Thank you for your question. 

Your post appears well documented but has not yet received any response. I am replying to raise awareness. Hopefully, another community member will be able to help.

Regards,

Vivek N
Community Moderation Team.

[MohaSharifi]

Hi Vivek,

Thank you

[Chris3]

I am not able to reproduce that in Creo 9. Is it possible to share a simplified model with the issue?

[MohaSharifi]

Hi Chris,

I attached the drawing and drawing option settings. I wanted to have all units in mm in the drawing option and changed most of them but I don't know which option controls dimension line length in inspection mode.

 

[Radovan_DT · Accepted solution]

Figured it out its "dim_text_gap", your settings have 5, I am using 1

[MohaSharifi]

Thank you Radovan. It works!

[vnamboodheri]

Hello @MohaSharifi, 

It looks like you have some responses from some community members. If any of these replies helped you solve your question please mark the appropriate reply as the Accepted Solution. 

Of course, if you have more to share on your issue, please let the Community know so other community members can continue to help you.

Thanks,
Vivek N.
Community Moderation Team.

[MohaSharifi]

Hi Vivek,

Thank you for your help and raising the topic.