Dimension to datums not shown

[kdirth]

In wildfire 4.0 I was able to select a drawing view and activate the model tree for that view. This allowed me to select a point, coordinate system, plane, etc for a dimension without is being visible. Sometimes there are too many when the layer is shown.

In Creo I can not find this function and it always selects the item in the original view.

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[StephenW · Accepted solution]

I believe it is not there. There is a product idea for this. Please vote for it.

Drawings bring back "Use Model in Tree" from Wildfire 4.0

The comment under the idea says to use "set/add drawing model" but this is NOT the same as "use in model tree".

[kdirth]

Thanks, I have voted for this idea as it can be very useful when detailing complex parts or large assemblies.