Hello!I've had this issue lots of times. However, I cannot duplicate the problem on demand, so PTC will not allow me to report it as a bug. It's minor, but frustrating. Anyone else had this?
1. I place a dimension to the tangent / quadrant point of an arc, which is where I want it....(something the toolmaker can measure to)
2. Usually after a regenerate active model command, or closing and re-opening the drawing, the dimension toggles to the center of the arc.
Btw, support wrote this off to a graphics card issue. However, it happens to me at work and at home. Both pcs are high end performance with different video cards.