All,
We have had several users that started experiencing an issue with their dimensions not showing up in their models when the edit/edit definition features. The witness and extension lines show up, but no dimensions. Another user from this same group reports that they have where their dimensions show up, but they're scattered all over the place, not near the witness lines are.
Also we've experienced that sometimes when we call up a drawing our Section Arrows and Datum References are huge. They just about cover the entire drawing.
We found out that if we exit and go back in this usually fix both of these issues.
Is anybody else, using Wildfire 5 M080, experienced these particular issues? We can't reproduce it using any particular steps it only appears after a certain length of time.
Carpe Diem,
"Happiness equals reality minus expectations"
Michael Heath
Schlumberger Reservoir Completions
14910 Airline Rd.
Rosharon, TX 77583
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
