Community Tip - You can Bookmark boards, posts or articles that you'd like to access again easily! X
Hello, everyone.
For Creo 8, I am setting a repeat region to generate a BOM for my top level assemblies.
Some of my concerns are:
I have tried what is shown in this post but it didn't work. I have already done:
Any help will be very appreciated.
Regards.
Can you zip the drawing and assembly and upload it?
If not the actual assembly, a sample of what you have to work with.
Hi,
maybe tip from following article will help you.
https://www.ptc.com/en/support/article/CS129693