cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Drawing View Resize

sstavos
1-Newbie

Drawing View Resize

Is it possible to change the size of a drawing views boundaries? The drawing views are so large that they over lap each other.

I know why the drawing view is sized the way it is, the geometry is far away from the default Csys.

Steve


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1
StephenW
23-Emerald II
(To:sstavos)

Make your view a "partial view" under the "visible area" in the view properties dialog box and sketch the spline around the view. It will reduce the size of the view boundary to fit more appropriately.

Top Tags