cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Drawing dimensions explode from view

nicfre1
1-Newbie

Drawing dimensions explode from view

Pro-Gurus,
I am using Wildfire M200...
I know I have ranted on this once before, but today I am really fired up
over something that happens once in awhile while in a drawing. This
morning I was working on a drawing with quite a few dimensions located in
a specific view. I located all of the dimensions around the view where I
wanted them. I was going back and forth between the part and the drawing
making minor changes to the part, when all of the sudden, in that one view
all of the dimensions exploded from the view like I had just used the show
all random placement of the dimensions. What a mess! All of the views have
had this happen in this drawing. Has anyone else run into this problem and
if so, has anyone taken out any call numbers with PTC I can reference when
I take out a number. This is an absolute time waster to have to fix this
problem. Thanks.

Nick

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Announcements