... need help with creo config setting up:
i use dual dimensioning on drawings and need help with setting up maximum number of digits (to 1 or 2 more than primary) at dual secondary dimensions as below
there are 13digits behind zero until i tick the "rounded dimension value" at each dimension separately
Is there some possibility to set up that all secondary dimensions are rouned automaticaly?
a printscreen of confin.pro:
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
