cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Edit Explode State Lines to repair broken references

danderson
Garnet

Edit Explode State Lines to repair broken references

Good Morning Everyone,

Really hoping PTC has fixed this issue when a component is replaced and references for explode lines are lost.

It sure would be nice to be able to edit references in Creo 4 for lost references related to explode lines for explode states in assembly mode.

Yes if you use the edit references dialog in creo 2 or later you can avoid this issue. But if one fails to do this then you are left to delete and recreate them.

PTC Please add this to Creo 4!

Surprised there are not more votes on the enhancement below.

Thanks,

Don Anderson

Reference:

Explode lines editing in an expolde state; Re-establish a new reference.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Announcements