Exit Countersink fails on cylindrical surface

[yyuan]

Hi,

Just wondering if anybody has faced this issue. I am trying to drill a through hole on a cylinder from side. It is a standard hole. I would like to put counter sink on both side. Now it just fails every time when I pick the "exit countersink" option. The enter side counter sink is fine.

Anybody knows how to make this work?

Thanks

   "One or both the hole entry and exit surface not planar.

   Feature regeneration failed."   --Message Log

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[TomD.inPDX]

I simple add it as a revolve after the fact.  A lot of my designs have irregular surfaces on one or both sides.

[yyuan]

I did the same thing so far.

But the headache is that the note of the hole has to be modified manually every single time.