Family Table BOM Balloon

[Ketan_Lalcheta]

Hello,

I have an assembly with two instances into family table. I have generated drawing from the main file and created repeat region of Two-D type to accommodate BOM in a single table for all instances.

Issue I am facing is that even though it is a repeat region, the same table is not being recognised as repeat region when I intended to do ballooning of view using Create Balloons - All.

Requesting help on this.

I am open to share my test parts on which I am facing issue for your better understanding if required.

Thanks and Regards

Ketan

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[TomU]

Ketan,

If you are willing to use the advanced editor and upload your parts and drawings, I am willing to take a look at them.

Tom

[Ketan_Lalcheta]

I am more interested in to do ballooning of view having family table instances. I am also not able to find how to attach parts?

[TomU]

When you reply to this message, choose "Use advanced editor" in the upper right corner. The advanced editor will allow you to attach files.

[Ketan_Lalcheta]

Hi,

Please find attached model.

Regards

Ketan

[TomU]

Apparently you are using either an evaluation copy or a student copy, so I am unable to open them. Maybe someone else can chime in here who has one of those versions...

[Ketan_Lalcheta]

Hi,

I will be able to provide the same without evaluation or student by mid of next week.

Thanks and Regards

Ketan

[Ketan_Lalcheta]

Hello,

Please find attached model.

Table present into model is not been recognized as BOM table for ballooning.

Moreover, I am not able to replicate the model which I prepared into creo 3.0 trial version into creo 2.0 M090. This issue I am least interested as of now.

My main pain area is that how I am able to do ballooning using table.

Regards

Ketan