cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

The community will undergo maintenance on October 16th at 10:00 PM PDT and will be unavailable for up to one hour.

GD&T True Position Tolerance Appearance In Model and Drawing

zientarad
2-Guest

GD&T True Position Tolerance Appearance In Model and Drawing

Hi everyone,

 

I do not want my true position tolerance showing up like this with the long leader line. I want it to show up with a short leader line that ends when the text starts. Does anyone know how to change this setting? See attached. 

 

To create this GD&T I was in the .PRT file, annotate tab, and picked on "Geometric Tolerance"

 

Then clicked on the hole note and all of a sudden my nice looking short leader line turned in to a long leader line. It ALSO shows up this way on my drawing.

Thanks,
Dan

 

5 REPLIES 5
j_k
6-Contributor
6-Contributor
(To:zientarad)

Anyone have an answer?


JK - Creo 6.0.4.0
StephenW
23-Emerald II
(To:j_k)

@j_k 

Try changing the text orientation under display.

StephenW_0-1666118021695.png

 

TomU
23-Emerald IV
(To:StephenW)

@StephenW,

That only works for dimensions.  This is a standard hole note.

TomU
23-Emerald IV
(To:j_k)

It seems to be caused by the leader being from a note instead of from a dimension. 

 

TomU_0-1666118661328.png

 

You could open a case with tech support and ask why, but I'm guessing they'll say it's is "working to spec".

Chris3
21-Topaz I
(To:zientarad)

If you create an idea for this I will vote for it. I played with Creo 10 (early build) briefly at the Orlando conference and I can report that it does the same thing there.

Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags