cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

We are working to address an issue with subscription email notifications. In the meantime, be sure to check your favorite boards for new topics.

Getting error message "The section is not perpendicular in this view: select again."

ArekTRI
12-Amethyst
12-Amethyst
‎Feb 20, 2019 08:04 AM
‎Feb 20, 2019 08:04 AM

Getting error message "The section is not perpendicular in this view: select again."

Hi Creos,

 

I am facing this error which was registered as SPR 1410164.

https://www.ptc.com/en/support/article?n=CS51439&source=SPR%20Viewer

(Getting error message "The section is not perpendicular in this view: select again." when trying to arrows in a drawing view in Pro/ENGINEER and Creo Elements/Pro)

 

Is this bug repaired?

 

Thank you.

Arek

Creo 3 user
Labels:
0 Kudos
Notify Moderator
1 REPLY 1
StephenW
23-Emerald II
23-Emerald II
(To:ArekTRI)
‎Feb 20, 2019 08:23 AM
‎Feb 20, 2019 08:23 AM

Well, unlikely since it says it "works to product spec". Is this an offset x-sec? 

Resolution

  • Reported to R&D as SPR 1410164
  • Works to product specification for Pro/ENGINEER，Creo Elements/Pro and Creo Parametric
  • For an offset X-sec, the arrows can only be shown in a view in which the sketching plane for the xsec is flat to screen.
0 Kudos
Notify Moderator
Top Tags