I'm new to this forum and starting to learn Creo Cabling. Definitively the hardest one to understand is the Manufacturing/Flattening module.
Working on a relatively small harness and for some reason I get the "Could not create a starting location" when trying to Set Start Pnt in LAY OUT command. The harness regenerates and nothing is failing. I've tried picking different points all over the harness network with the same results. Any ideas on where to go from here?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
