I have wires autorouted to connectors. Some of the connectors have 90° Backshells.
What are the tips and tricks out there to actually get my backshell to line up with the connector and the routed cables again?
The connector and backshell are no longer constrained to one another in Harness MFG, so once I bend the wire to try and get it to follow thru the backshell, location points begin to overlap & fail, the backshell and connectorare not aligned... etc.
I know this is nothing new - I am still using WF4 - Just looking for experienced advice.
Thanks!
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
