Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X
Your question:
Is it possible to create a CREO tutorial about making a helical sweep (two or three coils is enough) out of a pipe that has grooves on the exterior? The pipe should go straight, do two or three 360-degree coils, and then become straight again. The section of the pipe looks like this, four equal grooves, rectangular, 90 degrees apart.
This video has been created based on a question from you - youtube subscribers. Feel free to contact me or leave a comment, or idea for another Creo tutorial.
If you enjoy my content, please consider supporting what I do: Buy a Coffee for 4KSide - https://ko-fi.com/J3J6B8N0 Vladimir Palffy - www.4kside.com