cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Help! How to define the contact interfaces and the fasteners.

CaiMingWu
Newbie

Help! How to define the contact interfaces and the fasteners.

Help: How to define the contact interfaces and the fasteners.


I defined the contact interfaces and the fasteners. But cannot start the solver, the warning message is as below.

"No contacting surface pair could be automatically detected for the creation of
separation stiffness. The separation stress measure for this fastener may be incorrect.

Source: Solver"

The model is created in Creo 1.0 . It.s in the attached files.
It's a simplify model of a actual project.

1 REPLY 1

Re: Help! How to define the contact interfaces and the fasteners.

It's quiet here.

After clean up the interference geometry of the hole, I can start the solver successfully.

Announcements