cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Hidden Line for tapped hole

wrbird
5-Regular Member

Hidden Line for tapped hole

I've added a cosmetic thread to a tapped hole in order for it to show up in my drawing.  However it shows up in my drawing as two solid line circles when the inner circle should be solid line and the outer circle should be a hidden line.  How can I get the outer circle to show up as a hidden line circle?

2 REPLIES 2
Mahesh_Sharma
22-Sapphire I
(To:wrbird)

@wrbird

 

Can you share a sample data? 

wrbird
5-Regular Member
(To:Mahesh_Sharma)

I figured it out.  The Creo drawing shows the tapped hole has two solid lines as shown in 2020-02-11_145918.jpg.  However, when I saved the drawing as a PDF, the major diameter circle "prints" as a hidden line as shown in 2020-02-11_150132.jpg.

Top Tags