cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Hole on surface

VladimirPalffy
Amethyst

Hole on surface

Short demonstration of how to create a hole on any surface

 


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Best Regards,
Vladimir Palffy
4 REPLIES 4

Re: Hole on surface

OMG

Re: Hole on surface

Nice demonstration!

Bob

Re: Hole on surface

I had tried that - if you look in my post, the hole went horizontal instead of vertical as yours did. I'm not sure why. 

But thank you! Very helpful!

Re: Hole on surface

Hi Kris,

Hole is always gone thru perpedicular to the surface point made

Announcements