cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

How to create a helical cable in the Cabling application

agoksu
Newbie

How to create a helical cable in the Cabling application

Hi friends. I'm researching that how to create helical cable in cabling. I found a method but it's not practical.

My method is;

  1. Create curve through helical sweep
  2. Create a ratio datum point that is located on the helical sweep.
  3. pattern point by increment 0.01
  4. Route the cable through these points

Disadvantage of this method, there are too much points (about 50-100) and ı have to select these one by one. (can't select as a whole by shift key).

Do you know another method (and more practical) to create a helical cable in the cabling application. Help Please?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1

Re: How to create a helical cable in the Cabling application

There is a lot of good information in this thread that should be able to help you with this problem.

http://communities.ptc.com/message/244276#244276

Thanks, Dale

Announcements