How to indicate a hole as a clearance hole or a tap hole in a drawing hole table in Creo Parametric?
What is the best method to indicate a hole as a clearance hole or a tap hole in a drawing hole table when using standard holes or custom hole (*.hol) with parameters?
A1 is a through hole that is tapped.
B1 is a through hole that is a clearance for a bolt
Both are shown as the same type of hole in the hole table.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.